OPERATING THE ELECTRONIC MONITOR
1.To turn on the power, press the on/reset button or simply begin exercising on the AIR STRIDER. The entire display will appear for two seconds. The electronic monitor will then be ready for operation.
2.Select one of the five modes:
Scan modeÑWhen the power is turned on, the scan mode will be selected automatically. The scan mode can also be selected by repeatedly pressing the mode button. One mode indicator will show that the scan mode has been selected, and a second mode indicator will show which mode is currently displayed.
Speed, time, distance, or calories modeÑ These modes can be individually selected by repeatedly pressing the mode button. The mode indicators will show which mode has been select- ed. (Make sure that the scan mode is not select- ed.) The modes will be selected in the following order: speed, time, distance, calories, scan.
3.The monitor has an
To reset the LCD display, press the on/reset button.
STORAGE AND TROUBLE-SHOOTING
Inspect and tighten all parts of the AIR STRIDER reg- ularly. Replace any worn parts immediately. The AIR STRIDER can be cleaned with a soft, damp cloth. Keep liquids away from the electronic monitor. Keep the monitor out of direct sunlight or the display may be damaged. Remove the batteries when storing the
AIR STRIDER.
HOW TO FOLD THE AIR STRIDER FOR STORAGE
When the AIR STRIDER is not in use, it can be folded for compact storage. To fold the AIR STRIDER, first remove the lock knob and lock washer from the right leg. Next, hold the resistance dials and fold the frame and the uprights together. Place the AIR STRIDER in a location where it cannot fall.
Lock | Resistance |
Washer | |
Lock | Knob |
| |
Knob |
|
Upright | Frame |
REPLACING THE BATTERIES
If the display of the electronic monitor becomes dim, or if the monitor does not function properly, the batter- ies should be replaced. To replace the batteries, refer to assembly step 6 on page 6.
HOW TO ADJUST THE REED SWITCH
If the speed and distance modes do not display cor- rect information, the reed switch should be adjusted. The reed switch is
located below the |
|
|
|
|
|
|
|
|
|
|
electronic monitor |
|
|
|
|
|
|
|
|
|
|
(see the drawing at |
| Magnet |
|
|
|
|
|
|
|
|
the right). Loosen the |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
screw in the reed |
|
|
|
|
|
|
|
|
|
|
switch, move the reed |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
switch to the side |
|
|
|
|
|
|
|
|
|
|
slightly, and retighten |
|
|
|
|
|
|
|
| ||
|
|
|
|
| Reed |
| ||||
the screw. Make sure |
|
|
|
|
| Switch |
| |||
that the reed switch |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
does not hit the |
|
|
|
|
|
|
|
|
|
|
indicated magnet when the AIR STRIDER is in use. Repeat until the speed and distance modes display correct information.
8
