HOW TO ADJUST THE RESISTANCE BELT
If the pedals do not have enough resistance, even when the resistance knob is turned to the maximum setting, the Resistance Belt (49) may need to be adjusted. To adjust the Resistance Belt, the left side shield must first be removed. Refer to the instructions on page 11 to remove the left side shield.
the Belt by pulling it slightly and then refasten the end of the Belt. Turn the Crank (7) for a moment to make sure that there is not too much resistance. When the Resistance Belt is properly adjusted, reattach the left side shield and pedal.
BATTERY REPLACEMENT
Next, turn the resistance knob to the lowest setting. (See
HOW TO ADJUST THE PEDALING RESISTANCE on page 9.) Locate and grip the end of the Resistance Belt (49). Peel the end of the Resistance Belt down as shown in the inset drawing. Tighten
7 |
49 |
1 |
49 |
If the console does not function properly, the batteries should be replaced. See assembly step 3 on page 6.
12