Preparing the device for use / Operation
Blade guard 2 :
The Blade guard 2 must be in place whenever you operate the saw.
Push stick 12 :
The supplied push stick 12 serves as an extension to your hand when feeding the workpiece into the saw (for use see fig. F).
Always use the push stick 12 if the distance between the guide fence 1 a and the blade 4 is ≤ 120 mm.
Safety ON / OFF switch with
Overload switch / overload protection (Reset 17 ) (Fig. H)
If the machine is overloaded, the protection mecha- nism automatically switches the machine off.
The machine can only be switched back on again by first pressing the reset switch 17 and then the ON / OFF switch 16 .
jIf there is still an overloading problem, check whether:
-very hard wood was being sawn too quick- ly (feed speed)
-there has been a drop in speed / a rise in power consumption
-very moist wood was being sawn (high braking effect)
-the machine is choked with saw dust
-the saw blade is blunt
Vacuum dust extraction connection
2a & 20:
jIf you are working in an enclosed space you must use a suitable vacuum dust extraction de- vice (see Fig. F). If you are not working with a vacuum dust extraction device then the dust will collect inside the housing and must be re- moved after 30 minutes of operation (maximum).
36 GB/MT
jYou can connect the vacuum dust extraction device to the vacuum dust extraction connection 2a or the vacuum dust extraction connection 20 or to both, as you like.
jConnect a special vacuum extraction device or a sawdust extraction system to the vacuum dust extraction connection 2a and / or vacuum dust extraction connection 20.
jUse the appropriate extraction adapters 21 and 22 (see Fig. B).
QAssembly
jAttach the blade guard 2 to the riving knife
3 . The underside of the blade guard 2 must be horizontal and lie flat on the saw table 5 / workpiece with the saw blade 4 moving free- ly beneath it.
jMount the guide fence 1 and / or the mitre guide 8 into the guide slots 6 , depending on the type of work you are doing.
QOperation
Warning! The voltage must agree with that shown on the machine rating plate (equipment shown as 230 V can also be connected to 220 V). The electrical circuit must be fitted with 16 A protection.
Blade height adjustment:
The table saw has a patented
jSet the blade height (cutting depth) by turning the hand wheel 14 .
Setting the blade angle:
jRelease the safety lock thumb knob 13 .
jSet the inclination angle of the saw blade 4 using the blade angle adjustment thumb knob 18 to any angle between 0° and 45°. The desired angle can be read off the blade angle scale 15 . Tighten the safety lock thumb knob 13 .
