Weslo WLEX27181 user manual

1.Loosen the Frame Knob (29) on the right side of the Frame (1). Slide the Seat Frame (2) out until it stops. Tighten the Frame Knob.

2.Route the Extension Wire (56) down through the Handlebar Post (3) and plug it into the Reed Switch Wire (42). Push the Resistance Cable (57) up through the Handlebar Post.

Attach the Handlebar Post (3) to the Frame (1) with three M8 x 15mm Button Head Screws (53) and three M8 x 19mm Washers (54). Be careful not to pinch the Reed Switch Wire, Extension Wire or the Resistance Cable.

3.Plug the Extension Wire (56) into the back of the Console (33). Push the Resistance Control (31) into its socket in the Console.

Next, connect the short cable on the Resistance Control (31) to the Resistance Cable (57) as follows:

¥Insert the tip of the short cable into the wire clip as shown in drawing A.

¥Firmly pull the short cable and slide it into the metal bracket as shown in drawings B and C. Make sure that the tip of the short cable is held by the wire clip as shown.

Next, attach the Console (33) to the Handlebar Post

(3) with four #8 x 1/2Ó Screws (43).

4.The Console (33) requires two ÒAAÓ batteries (not included)Ñalkaline batteries are recommended. Remove the Battery Cover (59) on the top of the Console. Refer to the inset drawing. Press two bat- teries into the Console top. Make sure that the negative (Ð) ends of the batteries are touching the springs. Reattach the Battery Cover.

6

1
	29
1
	2
2	57
56
	3
53	53
54
53	54
42
1
3
	31
33	A
56
57
	Wire
	Clip
43
B	C
3
43
4	Batteries
59
33
	Console Top