Weslo WLTL01806.0 user manual Maintenance and Troubleshooting, Symptom the Walking Belt does not

MAINTENANCE AND TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual.

1. SYMPTOM: THE CONSOLE DOES NOT		3. SYMPTOM: THE WALKING BELT SLIPS OR IS
FUNCTION PROPERLY		OFF-CENTER
a. Replace the battery in the console (see assembly		a. If the walking
step 5 on page 6).		belt slips
		when walked
b. The console, like most electronics, is susceptible		on, use the
to static electricity build-up caused by certain		hex key to turn
types of clothing or by the operation of the tread-		both rear roller
mill. If the display is blank or gives incorrect read-		bolts clockwise,
ings, apply an anti-static spray to the handrails.		1/4 of a turn.
Anti-static spray is available where laundry sup-		When the walking belt is correctly tightened, you
plies are sold.		should be able to lift each edge of the walking belt
		2 to 3 inches. Walk on the treadmill for a few min-
2. SYMPTOM: THE WALKING BELT DOES NOT		utes. Repeat until the walking belt is properly tight-
MOVE SMOOTHLY		ened. Be careful to keep the walking belt centered.
a. If the walk-		b. If the walking
ing belt is		belt has shift-
overtight-	Walking	ed to the left
ened, per-		side, use the
	Belt
formance		hex key to turn
may be		the left rear
reduced and		roller bolt
the walking		clockwise, and
belt may be		the right rear roller bolt counterclockwise, 1/4 of a
permanently	2"–3"	turn each. Be careful not to overtighten the walk-
damaged.		ing belt. Walk on the treadmill for a few minutes.
	Bolts
Using the		Repeat until the walking belt is centered.
hex key,
turn both rear roller bolts counterclockwise 1/4 of		c. If the walking
a turn. When the tension of the walking belt is		belt has shift-
correct, you should be able to lift each edge of		ed to the right
the walking belt 2 to 3 inches. Walk on the tread-		side, use the
mill for a few minutes. Repeat until the walking		hex key to turn
belt is properly tightened. Be careful to keep the		the left rear
walking belt centered.		roller bolt coun-
		terclockwise,
		and the right rear roller bolt clockwise, 1/4 of a

turn each. Be careful not to overtighten the walk- ing belt. Walk on the treadmill for a few minutes. Repeat until the walking belt is centered.

11