3.Cut the indicated plastic tie off the Left Handrail (2).
Position the Left Handrail (2) on the left Upright (14). Loosely thread a Handrail Bolt (15) with a Handrail Washer (16) into the lower end of the Left Handrail and the left Upright. Next, loosely thread a Handrail Bolt (15) with a Handrail Washer (16) into the upper end of the Left Handrail and the left Upright. Do not tighten the
Handrail Bolts yet.
4.Have a second person hold the Console Base (6) and the Right Handrail (57) near the right Upright (14) as shown. Fold the Wire Harness (26) as shown and insert the folded Wire Harness into the Right Upright.
Cut the indicated plastic tie off the Handrail (57).
Make sure that the Wire Harness (26) is inside of the bracket on the Right Handrail (57) and insert the bracket into the right Upright (14). Make sure that the Wire
Harness is not pinched.
5.Position the Right Handrail (57) on the right Upright (14). Loosely thread a Handrail Bolt (15) with a Handrail Washer (16) into the lower end of the Right Handrail and the right Upright. Next, loosely thread a Handrail Bolt (15) with a Handrail Washer (16) into the upper end of the Right Handrail and the right Upright. Do not tighten the
Handrail Bolts yet.
6.Attach the Console Base (6) to the Left and Right Handrails (2, 57) with four 3/4” Screws (55 ).
Tighten all parts used in this step and steps 3 to 5.
7.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a se- cure place. The allen wrench is used to adjust the walk-
ing belt (see page 13). To protect the floor or carpet,
6place a mat under the treadmill.
3 |
|
15 | Plastic Tie |
| |
16 |
|
| 2 |
14 |
|
| 16 |
| 15 |
4 |
|
6 |
|
Bracket |
|
26 | Plastic Tie |
57 |
|
14 |
|
5 |
|
| 15 |
57 | 16 |
| |
| 14 |
16 |
|
15 |
|
6 |
|
57 |
|
6 |
|
55 |
|
2 |
|
| 55 |
