![](/images/new-backgrounds/1270809/2708099x1.webp)
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrench and your own phillips screwdriver | and | |
adjustable wrench | . |
|
Refer to the drawings below to identify the parts used in assembly.
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
3/4” Screw |
|
|
| Extension Leg |
| ||
Handrail Bolt | Handrail Washer | ||||||
| Screw | ||||||
|
|
|
| ||||
|
|
|
|
|
| ||
|
|
|
|
|
|
|
1.With the help of a second person, carefully raise the Uprights (14) to the position shown. Note that the Console Base (6) and the Right Handrail (57) are con- nected to the right Upright with the Wire Harness (26).
Be careful not to pull on the Wire Harness.
Refer to the inset drawing. Insert one of the Extension Legs (41) into the treadmill as shown. (Note: It may be helpful to tip the Uprights [14] in the direction shown by the arrow as you insert the Extension Leg. Make sure that the Base Pad [36] is on the bottom of the Extension Leg.) Attach the Extension Leg with an Extension Leg Screw (34). Be sure to push on the head of the
Extension Leg Screw while tightening it.
Attach the other Extension Leg (41) in the same way.
2.Attach the Storage Latch (12) to the Upright (14) with two 3/4” Screws (55). Be careful not to overtighten the
Screws.
1 |
| 26 |
|
| 6 |
|
| 57 |
|
| 14 |
|
| 14 |
|
| 34 |
|
| 41 |
|
| 36 |
2 |
|
|
|
| 14 |
| 12 | 55 |
|
|
5