Weslo WLTL22190 user manual Assembly, Be careful not to pull on the Wire Harness

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench and your own phillips screwdriver		and
adjustable wrench	.

Refer to the drawings below to identify the parts used in assembly.

3/4Ó Screw (55)Ð10	Handrail Bolt (15)Ð4		Extension Leg	Handrail Washer
			Screw (34)Ð2
				(16)Ð4
1. With the help of a second person, carefully raise the		1		26
Uprights (14), the Console Base (6), and the Right
			6
Handrail (57), until the treadmill is in the position shown.
Be careful not to pull on the Wire Harness (26).				57
Refer to the inset drawing. Insert one of the Extension
Legs (41) into the treadmill as shown. (Note: It may be				14
helpful to tip the Uprights [14] in the direction shown by
the arrow as you insert the Extension Leg. Make sure
that the Base Pad [36] is on the bottom of the Extension
Leg.) Attach the Extension Leg with an Extension Leg				14
Screw (34). Be sure to push on the head of the
Extension Leg Screw while tightening it.				34
Attach the other Extension Leg (41) in the same way.				41
				36
2. Cut the plastic tie holding the cage nut in the upper end		2
of Left Handrail (2).
				Plastic Tie
			15
Position the Left Handrail (2) on the left Upright (14).
			16
Attach the lower end of the Left Handrail first. Thread
a Handrail Bolt (15) with a Handrail Washer (16) into the				2
lower end of the Left Handrail and the left Upright. Do
			14
not tighten the Handrail Bolt yet.
Attach the upper end of the Left Handrail (2) to the left				16
Upright (14) with a Handrail Bolt (15) and a Handrail				15
Washer (16). Do not tighten the Handrail Bolt yet.

5