ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrench and your own phillips screwdriver | and | |
adjustable wrench | . |
|
Refer to the drawings below to identify the parts used in assembly.
3/4Ó Screw (55)Ð14 | Handrail Bolt (15)Ð4 |
| Extension Leg | Handrail Washer |
| Screw (34)Ð2 | |||
|
|
| (16)Ð4 | |
|
|
|
| |
1. With the help of a second person, carefully raise the | 1 |
| 26 | |
Uprights (14), the Console Base (6), and the Right |
| |||
| 6 | |||
Handrail (57), until the treadmill is in the position shown. |
|
| ||
|
|
| ||
Be careful not to pull on the Wire Harness (26). |
|
| 57 | |
Refer to the inset drawing. Insert one of the Extension |
|
|
| |
Legs (41) into the treadmill as shown. (Note: It may be |
|
| 14 | |
helpful to tip the Uprights [14] in the direction shown by |
|
|
| |
the arrow as you insert the Extension Leg. Make sure |
|
|
| |
that the Base Pad [36] is on the bottom of the Extension |
|
|
| |
Leg.) Attach the Extension Leg with an Extension Leg |
|
| 14 | |
Screw (34). Be sure to push on the head of the |
|
|
| |
Extension Leg Screw while tightening it. |
|
| 34 | |
|
|
|
| |
Attach the other Extension Leg (41) in the same way. |
|
| 41 | |
|
|
|
| |
|
|
|
| 36 |
2. Without removing the tape from the Latch (12), attach the | 2 | 14 |
| |
Latch to the left Upright (14) with four 3/4Ó Screws (55). |
| |||
|
| Spacer | ||
Make sure that the Screws are tight, but do not over- |
|
| ||
|
|
| ||
tighten them; if the Screws are overtightened, the |
| 12 | Springs | |
Latch will not slide smoothly. After the Latch is at- | 55 |
| ||
tached, remove any visible tape. |
|
| ||
|
|
| ||
Note: The inset drawing shows how the parts of the Latch |
|
|
| |
(12) fit together. |
|
|
|
|
|
|
|
| Latch |
|
|
|
| Bracket |
5
