Weslo WLTL29014 user manual Assembly, Harness 53 in the right Handrail

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dis- pose of the packing materials until assembly is completed. In addition to the included allen wrench, assembly

requires a phillips screwdriver , an adjustable wrench ©_ and scissors _- --_.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor- mal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Handrail Washer (80)--4

Handrail Star

Washer (2)---4

Latch Screw/Rack Screw (14)-14 Base Leg Screw (39)-2 Console Screw (3)=4

1.With the help of a second person, raise the Uprights (38) to the position shown. Note: During this step and step 2, be careful not to pull on or damage the Wire

Harness (53) in the right Handrail (4).

Insert one of the Base Legs (44) into the right Upright (38), with the Base Leg Pad (33) in the indicated position.

Using the included Allen Wrench (81), attach the Base81 Leg with a Base Leg Screw (39). Attach the other Base

Leg (not shown) to the left Upright in the same way. Note: A replacement Base Leg Pad (33) may be included. If a Base Leg Pad becomes worn and needs to be replaced, use the replacement Base Leg Pad.

33

2. Hold the Left Handrail (88) against the left Upright (38) as shown. (Important: If you are shorter than 5'8", align the upper two holes in the Handrail with the holes in the Upright; if you are 5'8" or taller, align the lower two holes.) Attach the Left Handrail with two Handrail

Bolts (1), two Handrail Washers (80), and two Handrail

53

Star Washers (2) as shown. Do not tighten the Handrail

Bolts yet.

3853

Make sure that at least 6" to 8" of the Wire Harness (53) is extending from the top of the Right Handrail (4). Feed the excess Wire Harness into the right Upright (38), and

hold the Right Handrail against the right Upright. Make80 sure that both Handrails are at the same height.

Attach the Right Handrail with two Handrail Bolts (1), two Handrail Washers (80), and two Handrail Star Washers

(2). Do not tighten the Handrail Bolts yet. Be careful

not to pinch the Wire Harness. Remove the tie from the Wire Harness and the Handrail.