2.Set the console assembly face down on a soft surface to avoid scratching it.
Identify the Right Handrail (33), which has a large hole in the location shown. Hold the Right Handrail near the console assembly.
Next, insert the console wire into the large hole in the side of the Right Handrail (33). Using needlenose pliers, carefully grasp the connector and pull the console wire out of the hole near the bracket on the Right Handrail.
3.Set the Right Handrail (33) on the console assembly. Make sure that the console wire is not pinched. Remove the tie from the bracket on the Right Handrail. If necessary, press the Cage Nut (102) back into place.
Start an M5 x 16mm Screw (85) with an M5 Star Washer (7) into the Right Handrail, and then start two M4.2 x 19mm Screws (10) into the Right Handrail. Tighten the M5 x 16mm
Screw and then tighten the two M4.2 x 19mm Screws; do not overtighten the Screws.
Attach the Left Handrail (not shown) to the console assembly in the same way. Note: There is no wire on the left side.
2 |
|
Console Wire |
|
Bracket | Connector |
| |
| Large |
| Hole |
Console | 33 |
| |
Assembly |
|
3 |
|
|
Console Wire | Wire Tie |
|
102 | 85 |
|
| 7 |
|
Bracket | 33 | 10 |
| ||
Console |
|
|
Assembly |
|
|
8
