ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver 
and adjustable wrench 
.
Note: The underside of the treadmill walking belt is coated with
1.Note that the Right Handrail (32) and the Console Base (not shown) are connected to the treadmill by the Wire Harness (53). During assembly steps 1 to 4, be careful to avoid pulling on or damaging the Wire Harness.
With the help of a second person, raise the Uprights
(38)to the position shown. Insert one of the Base Legs (44) into the right Upright as shown. Make sure that the Base Leg Pad (33) is in the indicated posi- tion. Using the included Allen Wrench (81), attach the Base Leg with a Base Leg Screw (39). Attach the other Base Leg (not shown) to the left Upright in the same way.
Note: One replacement Base Leg Pad (33) and Spacer (not shown) are included. If a Base Leg Pad becomes worn and needs to be replaced, use the replacement Base Leg Pad with the Spacer.
2.Using the top and bottom holes in a Handrail Spacer (3), attach the Handrail Spacer to the left Upright (38) with two Long Screws (56). Make sure that the ramps on the Handrail Spacer are on the inner side as shown.
Attach the other Handrail Spacer (3) to the right Upright (38) with two Long Screws (56) in the same way.
3.Attach the Storage Latch (16) to the left Upright (38) with the two Latch Screws (8). Be careful not to overtighten the Latch Screws.
1 | 32 |
|
|
| |
| 38 |
|
| 53 |
|
|
| 81 |
|
| 39 |
|
| 44 |
|
| 33 |
2 |
|
|
Use these |
| 38 |
|
| |
holes | 3 |
|
| 3 | |
| Ramps | |
| 56 | |
|
| |
56 |
|
|
3 |
|
|
|
| 8 |
38 |
|
|
| 16 |
|
5
