Weslo WLTL39323 user manual Large Rectangular Hole Bend 107 Ground Wire 108

2.Identify the Right Upright (10), which has a large rectan- gular hole near the upper end (see drawing 2b). Have a second person hold the Right Upright near the Wire Harness (17). Insert the end of the Wire Harness into the Right Upright and out of the rectangular hole near the upper end as shown. If necessary, use needlenose pliers to pull the Wire Harness out of the hole.

See drawing 2b. Locate the Left Upright (9). If the Latch Housing (77) is not attached to the Left Upright, remove the two Screws (76) from the Left Upright. Attach the Latch Housing as shown with the two Screws. Firmly tighten—but do not overtighten—the Screws.

3.Make sure that the Right Upright (10) is turned so it bends in the direction shown. Insert two 3” Bolts (47) with Washers (29) through the Base (82) and hand tighten the Bolts into the lower end of the Right Upright.

With the help of a second person, tip the treadmill onto its other side and repeat steps 1 through 3. Note: There is not a wire harness in the Left Upright (not shown). An extra Base Pad may be included.

4.With the help of a second person, set the treadmill flat on the floor so that the Right Upright (10) and the Left Upright (not shown) are vertical.

Hold one of the Handrails (85) near the Right Upright

(10). Insert the end of the Wire Harness (17) into the bot- tom of the Handrail and out of the indicated hole. Using the Silver Screw (107), attach the end of the ground wire to the small hole in the side of the Handrail.

5.Have a second person hold the Console Base (87) and the Handrail (85) in the position shown. Touch the Right Upright (10) to discharge any static. Insert the Wire Harness (17) through the two Plastic Ties (108) on the Console Base. Find the 3-wire connector on the end of the Wire Harness. Insert the connector into the red socket beneath the Console Base. The connector should slide easily into the socket and “snap” into place. If the connector does not slide easily and snap into place, turn the connector and then insert it. If the connectors are not inserted properly, the Console may be damaged when the power is turned on.

Insert the 5-wire connector into the black socket beneath the Console in the same way. Make sure that the connec- tors and wires appear as shown in the inset drawing. Insert the excess Wire Harness (17) down through the Handrail.

Securely tighten the Plastic Ties (108) to prevent the Wire Harness (17) from slipping. Then, cut off the ends of the Plastic Ties.

2a	10
		17
2b	17	10
9
77
76	Large	Rectangular
		Hole
	Hole
3	82	47
	10	29
Bend
4	107
Ground		17
Wire
Hole
	85
10
5
87	108
85
		17
		5-wire
10		3-wire
	17

7