Western Telematic CMS-16 manual

CMS-16

Console Management Switch

Firmware Version 2.00 and Higher

User's Guide

5 Sterling Irvine California 92618

(949) 586-9950 Toll Free: 1-800-854-7226

Fax: (949) 583-9514 http://www.wti.com

Contents

Main Warnings and Cautions: Page Table of Contents List of Figures 1. Introduction Typographic Conventions 2. Unit Description Page 3. Getting Started 3.1. Communication Parameters 3.2. Apply Power to the CMS 3.3. System SetUp Ports 3.4. Connecting your PC to the CMS 3.5. Communicating with the CMS Unit Page Page 4. Hardware Installation 4.1. Connecting Power to the CMS Unit 4.1.1. AC Powered Units 4.1.2. DC Powered Units 4.2. Configure Option Switches 4.2.1. Default Baud Rate (Sw1, Sw2, Sw3) 4.2.2. Default Handshake (Sw4, Sw5) 4.2.3. Default Response Message Format (Sw6) 4.2.4. Default Command Echo (Sw7) 4.3. Initialize Unit to Default Settings 4.4. Connecting Devices to the CMS 4.5. Application Example Page 5. Configuration 5.1. Access to the CMS Command Mode 5.2. System SetUp Ports 5.3. Password Functions 5.3.1. The Supervisor Password 5.3.2. The Port Passwords 5.4. Defining the Site ID and Supervisor Password Page 5.5.2. Port Modes 5.5.3. RS232 Port Configuration Menus Page Page Page Page 5.5.4. Network Port Configuration Menu Page Page 5.5.5. Implementing IP Security Page 5.6. Copying Parameters to All Ports 5.7. Save User Selected Parameters 6. The Status Screens 6.1. The Port Status Screen (/S) 6.2. The Port Diagnostics Screen (/SD) Page 6.4. The Port Parameters Screens (/W) Page 7. Operation 7.1. Any-to-Any Mode 7.1.1. Port Connection and Disconnection Page Page Notes: 7.1.2. Defining Hunt Groups 7.2. Passive Mode 7.3. Buffer Mode 7.3.1. Reading Data from Buffer Mode Ports 7.3.2. Port Buffers 7.4. Modem Mode 8. Saving and Restoring Configuration Parameters 8.1. Sending Parameters to a File 8.2. Restoring Saved Parameters 9. Upgrading CMS Firmware Page 10. Command Reference Guide 10.2. Command Response 10.3. Command Summary 10.4. Command Set [Enter] Enter Command Mode [Enter]+++[Enter] Resident Disconnect Sequence /C Connect /CP Copy RS232 Port Parameters /D Third Party Disconnect /E Erase Buffer /F Set System Parameters /H Help /I Default and Test /J Display Site ID /N Set Network Port Parameters /P Set RS232 Port Parameters /S Display Port Status /SD Display Port Diagnostics /SN Display Network Status /T Reset Network Port /U Save Parameters /UF Upgrade Firmware /W Display Port Parameters (Who) /X Exit Command Mode A. RS232 Port Interface B. Specifications C. Customer Service Trademark and Copyright Information Index A Index-1 B C Index-2 R S T U Index-3