/W Display Port Parameters (Who)
Displays configuration of an individual port, but does not allow the user to change parameters.
Ports with User Level command capability cannot display parameters for other ports.
Normally, the Port Parameters screen will not include the Port Password. Note however, that
when the Supervisor Mode is active, the /WP option can be used to display the password for
the target port. For more information, please refer to Section 6.4.
Availability: Supervisor / User
Format: /W[P] [x] [Enter]
Where:
PWhen the “P” option is included (e.g. /WP 5), the Port Parameters screen will
list the password for each port, if defined. Note that the Supervisor Password
will not be displayed. (Supervisor Mode Only).
xIs the port number or name. To display parameters for the Network Port, enter an
“N”. If the "x" argument is omitted, parameters for your resident port will
be displayed.
Note: In Port (User) Mode only, if the /W command is applied to the Network
Port, the Port Parameters Screen will only list the setting for the Sequence
Disconnect, the selected Logoff Character, and the status of the Accept Break
option.
Response: Displays port parameters.
Example: To display parameters for a port named "SERVER",access the Command Mode
from a port with Supervisor Level command capability, and type /W SERVER [Enter].
/X Exit Command Mode
Exits Command Mode, When issued at the Net Port, also ends the telnet session. Note that
exiting from Command Mode will not terminate port connections.
·Any-to-Any Mode: Exits Command Mode.
·Modem Mode: Disconnects and resets modem, hang-up message is sent, hardware line to
modem drops for 500 ms, and reset message is sent.
Availability: Supervisor / User
Format: /X [Enter]
Response: Disconnected
10-10
CMS Series - Console Management Switches, User's Guide CommandReference Guide