Western Telematic M, MPC-16H-1, MPC-16H-2, MPC-18H-1, MPC-18H-2, MPC-20V-1, MPC-20V-2, MPC-20VD32-3, MPC-20VS30-1, MPC-20VS30-2, MPC-20VS32-3, MPC-8H-2, MPC-DISPLAY, MPC-20VD16-3, MPC-20VD20-2, MPC-20VS16-3, MPC-20VS20-1, MPC-20VS20-2, MPC-8H-1 Warnings and Cautions:

Warnings and Cautions:

If Secure Racked units are installed in a closed or multi-unit rack assembly, they may

require further evaluation by Certification Agencies. The following items must be

considered.

1. The ambient within the rack may be greater than room ambient. Installation

should be such that the amount of air flow required for safe operation is not

compromised. The maximum temperature for the equipment in this environment is

55°C. Consideration should be given to the maximum rated ambient.

2. Installation should be such that a hazardous stability condition is not achieved due

to uneven loading.

3. Side vents are used to dissipate heat generated within the unit. When mounting

the unit in an equipment rack, make certain to allow adequate clearance for

venting.

Check nameplate ratings to assure there is no overloading of supply circuits that could

have an effect on overcurrent protection and supply wiring.

Reliable earthing of this equipment must be maintained. Particular attention should

be given to supply connections when connecting to power strips, rather than direct

connections to the branch circuit.

Do not attempt to repair or service this device yourself. Internal components must be

serviced by authorized personnel only.

• Shock Hazard - Do Not Enter

• Lithium Battery

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace

only with same or equivalent type recommended by the manufacturer.

Discard used batteries according to the manufacturer's instructions.

Western Telematic Warnings and Cautions: