INSTALLATION
INSTALLATION PROCEDURE
1.The bench cutout should be made as per cutout dimensions in Figure 4.
2.Adjacent walls, cupboards and protection for combustible materials.
Ensure that the appliance is installed with
Section 5.12.1 of AS 5601 (Australia) or section 14.1 of NZS 5261 (New Zealand), regarding clearances to combustible surfaces and materials, and clearances to rangehoods and exhaust fans. To ensure clearances of 200mm from burners to vertical combustible surfaces observe the minimum dimensions shown in Figure 5.
Clearances to combustible materials may be reduced if combustible surfaces are protected in accordance with clause 5.12.1.2 of AS 5601 (Australia) or section 14.1.2 of NZS 5261 (New Zealand).
3.Optional Barrier
A barrier can be installed to prevent accidental contact with the cooktop base, where the base of the cooktop is accessible from below (i.e. inside a cupboard, etc).
An impression has been incorporated into the base to ensure a minimum clearance of 15mm is maintained between the base and the barrier. This barrier may be made of any
4.Fitting the cooktop into the bench Carry out as follows:
• Place the seals supplied around the bench
• Fit the
WARNING
Failure to fix the cooktop to the bench could result
in loosening of the gas connection through movement of the cooktop and a gas leak may result.
•Use the 4 clamps and screws supplied in the parts bag for 4 burner models, and 6 clamps and screws for 5 burner models.
•To assemble, attach the clamps to each corner of the burner box via the screws provided.
•Fix the clamps as shown in Figure 7. The clamp location points are shown in Figure 8.
•Remove excess seal.
•If the benchtop is less than the standard 33mm thickness, use a packer between the bench and the pull down clamps to ensure the cooktop is properly secured.
Figure | combustible surface |
| 131mm |
131mm | 119mm |
Figure | combustible surface |
| 131mm |
91mm | 79mm |
Figure 5–90cm models combustible surface
| 131mm |
111mm | 99mm |
