Safety Guidelines
CAUTION: The power supply outlet should be located near the LCD Monitor and should be easily accessible. Always use the appropriate AC cord that is certified for your specific country. Some examples are listed below:
USA | UL | Switzerland | .........SEV |
Canada | CSA | Britain | BASE/BS |
Germany | VDE | Japan | Electric Appliance Control Act |
IMPORTANT NOTICE CONCERNING POWER CORD SELECTION
The specific power cord for this LCD Monitor is enclosed and has been selected according to the country of destination and must be used to prevent electric shock. Use the following guidelines if it is necessary to replace the original cord set, or if the cord set is not enclosed. The female receptacle of the cord set must meet
Figure A1 | Figure A2 |
For the United States and Canada
In the United States and Canada the male plug is a
Cord Type | Size of Conductors in Cord | Maximum Current Rating of Unit | |
SJT | 18 AWG | 10 Amps | |
16 AWG | 12 Amps | ||
| 14 AWG | 12 Amps | |
SVT | 18 AWG | 10 Amps | |
17 AWG | 12 Amps | ||
|
FCC Compliance Statement
This equipment has been tested and complies with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and may cause harmful interference to radio communications if not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the LCD Monitor and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the Westinghouse Service Center or an experienced radio/Monitor technician for assistance.
FCC Warning
To assure continued FCC compliance, the user must use a grounded power supply cord and the provided shielded video interface cable with bonded ferrite cores. If a BNC cable used, use only a shielded BNC (5) cable. Also, any unauthorized changes or modifications not expressly approved by Westinghouse Digital will void the user's authority to operate this device.
3