12
MOUNTING AND WIRING INSTRUCTIONS
CAUTION: For fixtures labeled for outdoor and wet location use, provide a
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These fixtures meet all UL specifications.
1.Turn off power at circuit box to avoid possible electric shock.
2.Thread mounting screws (A) into mounting bar (B) approximately 1/4 inch (see fig. 1).
3.Secure mounting bar (B) to outlet box (C) with outlet box screws (D) (not included).
4.Identify color coding of fixture wires (see fig. 2).
5.To connect wires, take black fixture wire (group A from fig. 2) and place evenly against black outlet box wire. Do not twist wires.
6.Fit wire connector (E from fig. 1) over wires and twist until there is a firm connection. If wire connector (E) easily comes off, reattach and check again for a firm connection .
7.Repeat steps 5 and 6 with the white (group B from fig. 2) fixture wires and outlet box wires.
8.Partially thread green grounding screw (F) into side hole (G) on mounting bar (B) (see fig.1).
9.Wrap ground wire from fixture and ground wire (metal or green wire) from outlet box (C) around green grounding screw (F) on mounting bar (B).
10.Tighten green grounding screw (F). Do not over tighten.
11.Tuckwires inside outlet box (C).
FIXTURE ASSEMBLY INSTRUCTIONS
1.Line up holes in insulation (H) with holes in canopy top (I) (see fig. 1).
2.Raise canopy (I) to ceiling, allowing mounting screws (A) to protrude through key slots (J) in canopy top (I), and secure with cap nuts (K).
3.Install lamp(s). Do not exceed recommended wattage.
4.Turn power back on at circuit box.
4
