Steam Control Dial

Using as a Steam Iron

When steam ironing, the Temperature Control Dial must be positioned to at least the “” symbol -- located midway between the GREEN (• •) and LILAC (• • •) settings.

1.Turn the Temperature Control Dial to the “min” position and the Steam Control Dial to the “X” (no steam) position.

2.Make sure that the Iron is unplugged and has cooled completely before filling.

CAUTION: IF THE IRON IS HOT, DO NOT FILL WITH WATER.

3.Filling the Water Tank: Place the Iron in the horizontal position (on its Soleplate). Using the Filler Cup provided, slowly pour water through the Water Fill Opening until the Water Tank is filled to the Maximum Water Level Line; DO NOT OVERFILL. (See FIGURE 5.)

IMPORTANT: Use tap water or distilled water only. Do not use chemically descaled water or any other liquids.

MAX

FIGURE 5

4. With the Water Tank full, stand the Iron in the vertical position (on its Heel Rest) on a heat resistant surface and plug into a 120V outlet. An audible beep will sound and the Water Tank will glow blue.

5. Turn the Temperature Control Dial to the desired setting, between the “ ” and “ ” symbols. (See FIGURE 4 for basic fabric/temperature guidelines or check the condensed fabric guide imprinted on the Heel Rest of the Iron.) The red Thermostat Light will illuminate, indicating that the Iron is heating.

NOTE: For best results, check garment labels for the temperature setting recommended by the fabric manufacturer.

6. As the Iron is heating, the Water Tank will cycle through each color until the desired setting is reached. Once the Iron has reached the set temperature, an audible beep will sound and the red Thermostat Light will go off, indicating that the Iron is ready for use.

NOTE: The red Thermostat Light will continue to cycle off and on during use as the Iron maintains the desired temperature.

7.Turn the Steam Control Dial to the desired setting: “X” = no steam, “1” = low, “2” = high

(see FIGURE 6).

NOTE: For optimum steam output, the Temperature Control Dial should be set to the “max” (RED) position.

CAUTION: AVOID COMING IN CONTACT WITH

FIGURE 6

ESCAPING STEAM.

8.Press the Blast of Steam and Spray Buttons as needed (see

the following sections for a complete description of these features).

6