Models | 8.1 Pro | 8.2 Pro |
Type | 2 WAY | 2 WAY |
Usable frequency response | ||
Peak SPL @ 1m, short term IEC noise source | 106dB | 108dB |
Sensitivity | 86dB | 86dB |
Power Handling (Watts) | 100 W | 100 W |
Recommended amp power | ||
Impedance nominal | 4Ω | 4Ω |
Drive Units | 5"LF, 1" HF | 6.5" LF, 1" HF |
System Magnetic Shielding | Yes | Yes |
Crossover frequency | 2.2K | 2.2K |
Input connectors | 1 x phono speakon type /jack combo | |
Input connectors (active) | 1 x phono (unbalanced) | 1 x |
Active ie slew rate, distortion | 10v/micro s | 10v/ micro s |
Finish | IRIDIUM color laminate | IRIDIUM color laminate |
Dimensions H x W x D (mm) | 295 x 198 x 252 | 364 x 212 x 257 |
Dimensions of Active H x W x D (mm) | 295 x 198 x 280 | 364 x 212 x 322 |
Weight (each kg) | 5.2kg | 6.2kg |
Weight of active unit (each kg) | 7.5kg | 8.0kg |
Active units only: |
|
|
Usable frequency range | ||
Drive units | 5" LF, 1" HF | 6.5" LF, 1" HF |
Crossover frequency | 2.0K | 1.9K |
Output SPL ((from peak power) | 106dB | 108dB |
IEC weighted noise @ 1m) |
|
|
60W LF + 40W HF | 60W LF + 40W HF | |
Input sensitivity | 0.775V RMS (0 dBu) | 0.775V RMS (0 dBu) |
Amplifier system distortion at | 0.1% @ 50W | 0.1% @ 50W |
System Magnetic Shielding | Yes | Yes |
Signal to noise ratio | 100dB | 100dB |
Mains voltage: |
|
|
Voltage operating range at: |
|
|
230V setting | ||
115V setting | ||
Power consumption: |
|
|
Idle | 22W | 22W |
Full output | 130W | 130W |
Maintenance:
The high quality finish on your Diamond Pro is generally not in need of any care or attention. Do not use abrasives or abrasive materials to clean the enclosure since the finish may be marred. Never use water on or near electrical equipment.
The Diamond
Safety:
Always use grounded A/C power. Take care to mount and operate your equipment in a safe manner. Avoid exposure to rain and water.
Accessories:
Diamond Pro Series Subwoofer.
7
