Whirlpool 2184589 warranty Before Using Your Refrigerator, Cleaning your refrigerator, Plugging it

Before Using Your Refrigerator

It is important to prepare your refrigerator for use. This section tells you how to clean it, connect it to a power source., install it, and levei it.

Cleaning your refrigerator

Removing packaging materials

Remove tape and any inside labels (except the model and serial number label) before using the refrigerator.

To remove any remaining tape or label glue: l Rub briskly with thumb.

OR

l Apply liquid hand-dishwashing detergent to area before removing glue as described above. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners. These can damage the material. See “Important Safety Instructions” on page 3.

NOTE: Do not remove any permanent instruction

labels inside your refrigerator. Do not remove the Tech Sheet fastened under the refrigerator at the front.

Cleaning it before use

After removing all packaging materials, clean your refrigerator before using it, if necessary. See cleaning instructions on page 17.

Plugging it in

Recommended Grounding Method

A 115 volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord. See Electrical Requirements and Grounding Instructions Sheet in your Literature Package.

3-prong grounding type wall receptacle

Refrigerator power cord

3-prong grounding plug

Installing it properly

1.Allow l/2 inch (1.25 cm) space on each side and at the top of the refrigerator for ease of installation.

2.If the hinge side of the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider.

3.The refrigerator can be flush against the back wall.

Leveling	it	Ill
Your refrigerator	has two front leveling screws - one
on the right and one on the left. To adjust one or both
of these, follow the directions below.

1.Remove base grille. (See page 15.)

2.To raise front, turn screw clockwise.

3.To lower front, turn screw counterclockwise.

4.Check with level.

5.Replace base grille. (See page 15.)

Right to raise; ieft to lower

Use a screw- driver to adjust

5