4.Replace the crisper by sliding it back in fully past the drawer stop.
To remove the crisper cover:
1.Remove both crispers.
2.Holding glass insert firmly, grasp one side of crisper cover and lift the other side up from the bottom.
3.Slide the glass insert out to remove.
4.Lift cover frame up and remove.
NOTE: Before reinstalling the cover, make sure the U- shaped reinforcement bar is reinstalled.
To replace crisper cover:
1.Fit back of cover frame into supports on side walls of the refrigerator.
2.Lower front of the cover frame into place.
3.Slide rear of glass insert into cover frame and lower front into place.
Door Rails
The door rails may be removed for easier cleaning.
Snap-on Door Rails
To remove the rails:
1.Remove all items from the shelf.
2.Push in slightly on the front of the bracket while pulling out on the inside tab.
3.Repeat these steps for the other end of the rail.
To replace the rails:
1.Line up the ends of the brackets with the buttons on the sides of the door liner.
2.Firmly snap bracket and rail assembly onto the tabs above the shelf as shown.
Drop-in Door Rails
To remove the rails:
1.Remove all items from the shelf.
2.Pull straight up on each end of the rail.
To replace the rails:
1.Slide the shelf rail into the slots on the door.
2.Push the rail straight down until it stops.
Ice Maker Operation
(on some models)
After the freezer section reaches normal freezer temperature, the ice maker fills with water and begins forming ice. Allow 24 hours to produce the first batch of ice. Ice maker should then produce approximately 7 to 9 batches of ice in a 24
After ice is made, the ice cubes drop into the storage bin. When ice storage bin is full, ice maker arm raises to the “OFF” position (arm up). If ice is not needed, you can stop the ice maker by raising the arm to the “OFF” position (arm up). Listen for a click sound to be sure that the ice maker will not continue to operate.
To start ice maker, lower arm to the “ON“ position (arm down). Do not force arm up or down. Do not store anything on top of the ice maker or in the ice storage bin.
■The ON/OFF lever for the ice maker is a wire signal arm located on the side of the ice maker. Push the arm down to start making ice automatically, and push it up to shut off the ice maker.
■It is normal for the ice cubes to be attached at the corners. They will break apart easily.
■The ice maker will not operate until the freezer is cold enough to make ice. This can take as long as overnight.
15
