Toolsand materials neededfor installation:
Wes
- Cable clip
.(‘i
Power inlet’
u | 8 mm boxend |
| |
Pliers |
|
Nowstart
With compactor in room where it will be installed. Do not grasp console to move compactor.
Slide compactor onto cardboard or hardboard before moving compactor across floor to prevent damaging floor covering.
Do not allow the rear frame of compactor to touch the floor covering when lifting or moving compactor.
1.Remove compactor from shipping carton. Remove all protective packaging materials such as tape and shipping pads. Remove waxy residue caused by protective shipping material with a mild solution of liquid household cleaner and water.
2.Plug in power cord to compactor power inlet on the back panel. Power cord may be attached to cable clip.
3.Place two corner posts from carton on floor near compactor. Open compactor drawer and remove any shipping materials or other items shipped in the drawer. Do not remove the compactor bag
(if installed). Grasp the handle and raise the front of the drawer until it clears stops. Grasp sides of drawer and lift drawer out of compactor. Place the drawer on the two corner posts.
IMPORTANT: Use proper lifting methods in order to avoid injury.
