Wheel bracket assembly
4.Place the other two corner posts on the floor to the side of the compactor. Grasp the sides of the compac- tor cabinet and put compactor on its side on top of the corner posts. Remove the shipping base from the bottom of compactor.
5.The rear wheels are preset for a cabinet opening height of 86.4 cm (Position “A”).To adjust for other heights, loosen screw just enough to clear stud from hole in Position “A.”Move the rear wheel and stud to Position “B”or “C”as needed.
Position B: 87.4 cm
Position C: 88.1 cm
Tighten screw. Repeat for other rear wheel.
6. Place level inside on the floor of the cabinet. Check that the compactor is level from front to back and
side to side. Adjust the leveling legs until the , compactor is level.
7.Move the compactor close to its final position.
Plug the power supply cable into a properly earthed receptacle.
IMPORTANT: When moving or lifting the compactor, use gloves to protect and cushion your hands.
8.Carefully move compactor into its final position. Check that compactor is still level. (See Step 6.)
continued on next page
5
