L.P gas conversion
Converting to L.P. gas should be done by a qualified installer.
Fire Hazard
Shut off gas supply line valve.
Make all conversions before turning gas supply valve back on.
Failure to follow these instructions can result in explosion, fire or other injury.
J
Natural
A n Complete installation instructions, Steps 1 - 9 before converting your cooktop to L.P. gas.
Pressure regulator:
Use a wrench to unscrew the cap from the top by turning counterclockwise. Turn the cap over so the hole end is up. “L.P.” and “10” W.C.” should be visible on face of cap. Replace the cap and gasket on the regulator.
DO NOT REMOVE THE PRESSURE REGULATOR.
| pin | , | hood |
|
|
|
|
| |
Natural | gas y |
|
|
|
increase | gas |
|
|
|
increase | flame |
| \ |
|
size |
|
| ||
| L.P. gas |
| ||
factory | for |
|
| |
| decrease | gas | ||
Natural | gas) |
| ||
| decrease | flame | ||
|
|
|
size
B n Turn the orifice hoods down until snua against pin (approximately 2 to
C n After all the burners have been converted to L.P. gas usage, complete Steps 10 - 13, Panel D.
Adjusting for proper flame
Adjust the air shutters for proper flame by sliding the air shutter to close or open the shutter as needed. See Panel D, Steps
Natural gas conversion
Converting to Natural gas should be done by a qualified installer.
Fire Hazard
Shut off gas supply line valve.
Make all conversions before turning gas supply valve back on.
Failure to follow these instructions can result in explosion, fire or other injury.
L.P.Natural
A n Shut off main gas supply line valve and disconnect power supply cord before converting your cooktop to Natural gas.
Pressure regulator:
Use a wrench to unscrew the cap from the top by turning counterclockwise. Turn the cap over so the hole end is down. “Nat.”and “6” W.C.” should be visible on face of cap. Replace the cap and gasket on the regulator.
DO NOT REMOVE THE PRESSURE REGULATOR.
pin
Natural | gas | H |
| A |
| |
|
|
| ||||
increase | gas |
| 4 |
| ||
increase | flame | size | L.P. gas | |||
| decrease gas | |||||
for Natural | gas) |
| ||||
|
|
|
|
| decrease |
flame size
B n Loosen the orifice hoods away from pins 2 to
C n After all the burners have been converted to Natural gas, complete Steps 10 - 13, Panel D.
Adjusting for proper flame
Adjust the air shutters for proper flame by sliding the air shutter to close or open the shutter as needed. See Panel D, Steps
Panel E