10 n Carefullv tilt washer backwards until front of washer is
11 Use legs and nuts from parts n package. Screw nut down to
within l/2 inch (1.3 centimeters) of base.
12.
Insert legs into correct holes at each front corner of washer until nuts touch washer. Do Not tighten nuts until Step 15.
13 Tilt washer backward and n remove wood block. Gently
lower washer to floor.
Move washer to its final location. Remove cardboard or hardboard from under washer.
I I
14 Tilt washer forward, raising n back legs 1 inch (2.5
centimeters) off of floor to adjust rear self- leveling legs. Gently lower washer to floor. Check levelness of the washer by placing a carpenter’s level on top of the washer, first side to side; then front to back.
1
the front legs up or down to adjust Repeat Step 14.
When washer is level, use wrench to turn nuts on front legs up tightly against washer base. If nuts are not tight against washer base, the washer may vibrate.
Property Damage
Secure the drain hose to the tub or standpipe with the shipping strap removed from the back of the washer.
Failure to properly secure drain hose could result in water damage.
Measure and mark a point approximately 15 inches (38.1 centimeters) from the plug end of the shipping strap. Cut the shipping strap at this point.
Check that hose is not twisted or kinked and is securely in place.
strap
Put “hook” end of drain hose in tub or standpipe. Tightly wrap the shipping strap around the drain hose and tub or standpipe or inlet hose as shown in Figures
If a longer drain hose is needed, drain hose (Part No. 388423) and hose extension kit (Part No. 285442) are available from authorized parts distributors. If drain hose must be shortened, use hose kit (Part No. 285442).
Note: tf washer Is moved to adJust draln hose, the washer must be leveled again. Repeat Steps
17 I CHECK ELECTRICAL
1 n REQUIREMENTS.BESUREYOU HAVE CORRECT ELECTRICALSUPPLYAND RECOMMENDED EARTHING METHOD.
18 n Check that all parts are now installed. See parts list, Panel A. If there is an extra part, go back through steps to see which step was skipped.
19 Turn on water faucets and n check for leaks. Tighten
couplings if there is leaking. DO NOT OVERTIGHTEN;this could cause damage to faucet.
20 Check that you have all of W your tools. Check that the
shipping strap with 2 cotter pins and plug was removed from the back of the washer and used to secure the drain hose.
21 Untape power supply cord n and plug into earthed outlet.
22 Take a few minutes and read n the Use and Care Guide to
fully understand your new washer. Now start the washer and allow it to complete the regular cycle.
successfully installed your new Whirlpool washer. To get the most efficient use
from your new washer, read your Whirlpool Use and Care Guide.
[ Congratulations! )
Panel C
