Whirlpool 3360619 Before you start, Your safety and the safety Others is very important

Before you start...

Your safety and the safety of

others is very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.

This is the safety alert symbol. This symbol alerts you to hazards that can kill or

hurt you and others. All safety messages will be preceded by the safety alert symbol and the word “DANGER” or “WARNING”. These words mean:

DANGER

You will be killed or seriously injured if you don’t follow instructions.

WARNING

You can be killed or seriously injured if you don’t follow instructions.

All safety messages will identify the hazard, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

Do Not store or operate washer below 0°C (32°F) (some water may remain in washer).

See Use & Care Guide for “Winterizing” information.

Check location where washer will be installed. Proper installation is your responsibility. Make sure you have everything necessary for correct installation.

Untape and open washer lid. Remove packages and hoses from washer.

No. T20 Torx screws

On coin-operated washers, front access to the pump area is available by removing the two, No. T20 Torx screws and then removing the front panel.

Important: Observe all governing codes and ordinances.

Single washer	Grounded
installations require	electrical outlet
30 cm (12 inch)	is required. See
minimum risers to	Electrical
provide an air	requirements.
cushion and
prevent noise and
damage to valves.

Level floor: Maximum slope under washer — 2.5 cm (1 inch).

A floor drain should be provided under the bulkhead. Prefabricated bulkheads with electrical outlets, water supply lines and drain facilities should be used only where local codes permit.

Hot and cold water faucets must be within 1.2 meters (4 feet) of the back of the washer and provide water pressure 690 kPa (10-100 PSI). A pressure reduction valve should be used in the supply line where inlet pressure entering the building exceeds 690 kPa (100 PSI) to prevent damage to the washer mixing valve.

Water heater: Set to deliver 60°C to 70°C (140°F to 160°F) water to the washer.

Standpipe drain system: Needs a 5 cm (two-inch) minimum carry-away capacity of 64.4 liters (17 gallons) per minute. Top of standpipe must be at least 86.4 cm (34 inches) high and no higher than 183 cm (72 inches) from bottom of washer.

Support: Floor must be sturdy enough to support loaded washer weight of 143 Kg (315 pounds).

PAGE 2