Owner options (coin- operated models)
CAUTION: Disconnect power cord.
1.For WARM RINSE and WATER SAVER:
•Remove screws from each end of the console bottom.
•Pull the console bottom forward; lift and tilt it back.
a. WARM RINSE
•Connect J1 to J2 b. SAVE WATER
•Pull out tab on
2.If use of a larger coin vault, lock and key is desired, conversion bar in lower portion of coin vault area can be removed.
3.If additional security is needed, top and cabinet can be locked to washer back panel by using a “screw type” lock and key in space provided in top panel under console. The “screw type” lock and key are available from usual industry sources.
Typical full load sizes.
Load | Loading | Load | Loading |
Type | Suggestion | Type | Suggestion |
|
|
|
|
Mixed | 3 double sheets | Heavy | 3 pair pants |
Load | 4 pillowcases | work | 3 shirts |
| 6 pair shorts | clothes | 1 coverall |
| 8 |
| 4 pair jeans |
| 2 shirts |
| 1 overall |
| 2 blouses |
|
|
| 8 handkerchiefs |
|
|
|
|
|
|
Permanent | 2 double or | Knits | 3 blouses |
Press | 1 king size sheet |
| 4 slacks |
| 1 tablecloth |
| 6 shirts |
| 1 dress |
| 4 tops |
| 1 blouse |
| 4 dresses |
| 2 slacks |
|
|
| 3 shirts |
|
|
| 2 pillowcases |
|
|
|
|
|
|
Check list for washer operation
Check the following if the washer is not operating properly:
1.Power supply cord is plugged in.
2.Circuit breaker is not tripped or fuse blown.
3.Timer has been advanced to start of a cycle.
4.Water faucets are turned on.
5.Inlet and drain hoses are not kinked.
6.Washer lid is closed.
7.Inlet valve is frozen if not protected from the weather.
8.Suds level. Excess suds will slow the spin and cause poor rinsing. Operate the washer through a complete cycle with no detergent. Use less detergent or a controlled suds type detergent in future loads.
Operating Tips
WARNING
Fire Hazard
Never place items in the washer that are dampened with gasoline or other flammable fluids.
No washer can completely remove oil.
Do not dry anything that has ever had any type of oil on it (including cooking oils).
Doing so can result in death, explosion, or fire.
It is recommended that fiberglass items not be washed in coin- operated washers. If these items are washed in the washer, run the washer through a complete cycle to rinse any residue away that might be left in the washer.
Moving the washer to
a new location...
Wedge blanket between tub ring and cabinet top.
Remove front legs.
Tape rear | Tape 2 |
legs in “up” | |
position. | sides. |
| |
|
|
Note: Do Not place blanket in this area (switch).
•Remove the front legs from the base of the washer.
•Place both rear leveling legs in the upper position and tape securely.
•Apply tape to the side and bottom of the cabinet near the rear.
•Open washer lid, wedge a blanket between the tub ring and the cabinet top restricting the tub movement.
•Handle washer carefully. Do Not drop washer while using hand truck.
PAGE 6
