--7l!let valves are
Now start...
With washer/dryer in laundry area.
:
7
plastic. Do not
crossthread.
Personal Injury Hazard
More than one person is required to
lift, tilt or move the washer/dryer
because of its weight and size. Failure
to follow this instruction may result in
personal injury.
Truck only from rear to prevent product
damage.
I 5 n
Attach hose to bottom inlet valve
opening first; then second hose to top
inlet valve. Tighten couplings by hand.
Then use pliers to make an additional
two-thirds turn.
IMPORTANT: THIS PROCEDURE
MUST BE FOLLOWED TO ASSURE
PROPER INSTALLATION.
n
Pull to completely remove the
shipping strap with 2 cotterpins from the
inside of the washer/dryer.
1 I I n
Open washer lid. Take hoses and
parts packages out of basket. Close lid.
6 P n
TO prevent the drain hose from
Pull firmly to remove the
other end of the shipping strap from the
back of the washer/dryer. The shipping
strap plug must be completely removed
from the washer/dryer for the self-leveling
legs to be released.
Save the shipping strap for use in Step 15.
Use new hose and washers that came
with your washer/dryer.
coming off or leaking, it must be
installed per the following instructions:
1. Wet the inside end of the drain
hose with tap water. DO NOT USE
ANY OTHER LUBRICANT.
2. Squeeze ears of clamp with pliers
to open and place clamp over the
end of the drain hose.
3. While holding clamp open, work
end of drain hose onto drain
connector until drain hose is within
l/4 inch of ribbed stop.
4. When the end of the drain hose is
within l/4 inch of ribbed stop,
position
clamp on drain hose so
iflOT
tne oor;om of tne clamp 1s l/4
inch from the end of the hose,
release pliers.
7 mOpen clamp and
slide over “hook” end of
drain hose to secure the
rigid and corrugated
sections together.
l 1 hose clamp
l 4 flat, water-hose washers
l 4 cable-bracket screws
0 1 small clamp
2
n i?emcve pa,x frorr, pacitage
Check that all parts were included.
4
coupling wosher
n
Insert a flat washer into each end
of the inlet hoses. Check that washers
are firmly seated in couplings.
Numbers
correspond
to steps.
8.
16.
24.
Floor Damage
Slide washer/dryer onto cardboard or
hardboard before moving across
floor.
Failure to do so may cause damage
to floor covering.
8
n
If YOU have room to work from
either side of the washer/dryer, move
washer/dryer close to final position so
you can easily complete the following
steps. (Go to Step 9.)
If you are working in a closet or
recessed area, move the washer/dryer
into its final position and remove
cardboard or hardboard from under
washer/dryer. Remove the access
panel by removing three Phillips-head
screws and one bumper, located at the
top of the access panel. Set panel,
screws and bumper aside. (See Step
16.) Complete the following steps
through the access area.
9 n
Put “hook” end of drain hose into
laundry tub or standpipe. Check for
proper length of drain hose.
DO NOT FORCE EXCESS LENGTH OF
DRAIN HOSE DOWN THE STANDPIPE. THIS
COULD CAUSE SIPHONING.