Whirlpool 3395326 Recessed and closet, Product dimensions, installation instructions, Panel G

Recessed and closet	Product dimensions
installation instructions	Recessed area minimum installation spacing

This washer/dryer may be installed in a recessed area or closet.

The installation spacing is in inches and is minimum allowable. Additional spacing should be considered for ease of installation, servicing and compliance with local codes and ordinances.

If closet door is installed, the minimum unobstructed air openings in top and bottom are required. Louvered doors with equivalent air openings are acceptable.

Note: No other fuel-burning appliance may be installed in the same closet.

Other installations must use the minimum dimensions indicated.

Most installations will require at least 5 inch clearance behind the dryer for the dryer vent.

6"

Dryer

Washer

0" ***	0" *	0" *
Side View		Front View

Location must be large enough to fully open dryer door.

26-1/4"

28"

		48"
					5"
						72-3/4"
33	-		34	-3/4"
1/4"

32-1/4"

27-3/8"

Closet installation must be exhausted outdoors.

WARNING - To reduce the risk of fire, this appliance MUST BE EXHAUSTED OUTDOORS.

closet door closet door 0" ***

3"	6"
	48 sq. in. **
	48 sq. in. **

1" min.

	24 sq. in. **	24 sq. in. **
3"
front view		side view

*Additional clearances for wall, door and floor moldings may be required or if external exhaust elbow is used.

**Opening is minimum for closet door. Louvered door with equivalent air openings is acceptable.

***Additional space may be needed for exhaust elbow.

Exhaust outlet 36-3/4"

1-1/2"28-1/2"

hotDrain water 27"

inlet coldwater inlet

	13-1/2"
	recess
5"	width
	22-3/4"

recess depth

CRUSH	Dura Safe
RESISTANT	TM

SURE CONNECTTM Vent Kit

Periscopes For Offset

Outlets, Tight Installations

For more information, or to easily place your order, call

Kits Make Installation Easy

◆ Provides 4 1/2” clearance between dryer and wall

◆ Snap-Lock fittings

◆ Total kit length 8 feet

◆Provides 2 1/2” clearance between dryer and wall

◆Great for closet installations

◆0"-18", 18”-29” or 29”- 50” periscopes include one male snap-lock fitting, one extra long draw-band collar and one clamp

2 1/2"

2 1/2"

0"-18" : Part #4396037

18"-29" : Part #4396011

29"-50" : Part #4396014

1-800-442-9991

To have your venting

professionally installed,

call

◆ Additional vent can be snapped between

Part #4396028sections for

longer runs

Kit Contains:

2- 4' vent sections with attached close elbows1- Wall plate for close clearance installations

2- 4" clamps

.

Dura Safe and Sure Connect are Trademarks of Whirlpool, U.S.A.

0"-18" Periscope

◆ Use when vent outlets overlap or are offset

◆Excess length can

be trimmed to fit Part #4396037

18"-29" and 29"-50" Periscope

Sections separate,

fittings can face

Swivel collarsame or opposite wall connection

Telescoping		Swivel collar
sections
		Extra long
Beveled edges		band-clamp
		for dryer
allow corner
		connection
installations
18"-29" : Part #4396011	29"-50" : Part #4396014

1-800-253-1301

for the nearest

authorized service

provider.

Panel G