Whirlpool 3395339 manual Now start, With dryers in laundry area

timyg cam a

ratchet tooth

line up	notch	\	drive lug
to clear
ratchet	tooth.

4.Insert a narrow, flat-blade screwdriver under the timing cam near the clock shaft. Gently lift cam straight up and off shaft making sure that the “V-shaped notch clears the ratchet tooth.

5.Place new cam (hub side down) over clock shaft Line up flat side of shaft with flat side of cam hole.

Check that drive lug is in place.

6.Turn cam until “V-shaped notch lines up with ratchet tooth.

7.Press cam down in place on motor shaft. Make sure that “V”-shaped notch clears the ratchet tooth,

8.Reattach the timer bracket assembly; tighten the screws,

9.Repeat steps for other timer

10.Close and lock the control panel.

Now start...

With dryers in laundry area.

1 n

Check that each leg is

approximately 1 inch from base.

2.

Wipe the interior of the drums thoroughly with a damp cloth

3.

Install coin vaults and locks (not supplied) into meter case openings.

4.

Install control panel lock and key (not supplied).

Electrical Shock Hazard

Control panel must be closed and locked at all times.

Failure to do so could result in serious injury or death.

If you wish to change the 45minute dryer timing cams to either 30- or 60- minute timing cams, see “Tochange to a 30- or 60-minute timing cam,” Pages 7 and 8. Complete all of the steps given in that section before going to Step 6.

Electrical Shock Hazard

Disconnect electrical power at the service panel (fuse box or circuit breaker box).

Failure to do so could result in serious injury or death.

Open control panel and rest it on the bottom edge of the opening. Attach slide extension (with flange pointing down) to one of the coin-slide mechanisms, Insert the coin-slide mechanism through the opening to the left of the control panel.

7.

Secure coin-slide mechanism from inside the control panel using the

3/l 6” bolt and washer supplied. Install coin box.

8 n

Repeat Steps 6 and 7 for the other coin-slide mechanism. Close control panel.

9..

Insert top of wire guard into holes on each side of the coin-slide mechanism. Insert screws through hooked ends of guard and tighten. Repeat for other wire guard.

Page 8