When local codes... When local codes... When local codes.. .
C. D.DC NOT Permit
the use of a flexible
3-wire power supply cord and
Permit
copper power supply cable
and
DC NOT permit
the use of the flexible
power supply cord and
Permit
copper power supply cable
but
Permit
connecting cabinet-
grounding conductor to the neutral
(white] of the power supply cable:
DC NOT Permit
connecting cabinet-
grounding conductor to the neutral
wire of the power supply cable:
B. Permit
the use of a flexible-type
power supply cord (pigtail) but
DC NOT Permit
connecting cabinet-
grounding conductor to the wire of
the power supply:
Center silver-colored
terminal block screw Grounding
Neutral
IO
wi,re (green) Center silver-colored
terminal block screw Groundi$rz
, Neutral
(white or Center silver-colored
center) o terminal block screw
L\W/(sreen)
T‘ Grounding
94 wire
11
Internal
grounding
connector
nl
(white or
. .
External
grounding
connector
Ungrounded neutml
Figure 9
Connect separate copper
grounding wire (No. 10 minimum)
from external grounding
connector to approved ground.
1.
Remove the power supply cord
equipped with the washer/dyer
as instructed. See Panel F, “To
remove the power supply cord:
2. Connect the neutral wire (white]
of the power supply cord to the
center, silver-colored terminal
screw of the terminal block.
Connect the other wires to the
outer terminals. See Figure 9. For
plain-end wires, see ‘Direct
wiring connection,’ Panel F
3. Connect a separate copper
grounding wire (No. 10 minimum).
See “To connect a separate
grounding wire, Panel F for
detailed instructions.
4. Replace terminal block cover.
r*n*nn
“FI wa, /
Internal External
grounding grounding
connector
connector
Grounded neutral
Figure 10
1.
Remove the power cord
equipped with the washer/dryer
as instructed. See Panel F, “To
remove the power supply cord:
2. Install copper power supply cable
[See Electrical Requirements,
Panel A) through the strain relief.
3. Connect the harness grounding
wire (green] to the internal
grounding connector.
4. Connect the neutral wire of the
flexible armored or nonmetallic
sheathed copper power supply
cable to the center, silver-colored
terminal screw of the terminal
block. Connect the other wires to
the outer terminals. See Figure 10.
For plain-end wires, see ‘Direct
wiring connection,’ Panel F.
5. Replace the terminal block cover.
connect& grounding
connector
Ungrounded neutml
Figure11
Connect separate copper
grounding wire (No. 10 minimum)
from external grounding
connector to approved ground.
1.
Remove the power cord
equipped with the washer/dryer
as instructed. See Panel F, “To
remove the power supply cord:’
2. Install copper power supply cable
[See Electrical Requirements,
Panel A) through the strain relief.
3. Connect the neutral wire of the
flexible armored or nonmetallic
sheathed copper power supply
cable to the center, silver-colored
terminal screw of the terminal
block. Connect the other wires to
the outer terminals. See Figure 11.
For plain-end wires, see “Direct
wiring connection,’ Panel F
4. Connect a separate copper
grounding wire (No. 10 minimum).
See “To connect a separate
grounding wire, Panel F for
detailed instructions.
5. Replace terminal block cover.
Replace terminal
block cover.
This appliance is manufactured
with a 30 amp rated, four-wire,
flexible type power supply cord
with the green grounding wire
connected to the internal
grounding connector.
PANEL G