Whirlpool 761883306 manual Congratulations, Li!fs!fiiJ!L~, Non-ventedinstallation

16 W Lift range hood into final	5.1516.
position, feeding electrical wire through

wiring opening. Position the range hood so that the large end of the keyhole slots are over the screws, Then push the hood

toward the wall so that the screws are in the neck of the slots. Tighten mounting screws to cabinet, making sure mounting screws are in narrow neck of slots. Make sure that damper blade, if used, rotates up and down freely.

screw

17 W Connect the white and black wires of the power supply cable to the white and black leads in the hood with twist-on connectors.

Connect the power supply grounding wire to the green, grounding wire inside the range terminal box with a twist-on wire connector.

Use caulking to seal wire opening. Replace terminal box cover.

18 n Pull firmlv on tab to remove filter/light lens from range hood. Turn filter/light lens so that charcoal filter pad is facing up. Lift tabs and remove charcoal filter pad. Discard charcoal filter pad. Place edge of filter/light lens in opening so that right side is above flange and tab faces downward. Press filter/light lens into position.

-

4 H Remove terminal box cover on range hood.

Injury Hazard

More than one person is required to help with installation because of the weight and size of range hood.

Failure to follow this instruction could result in serious injury.

keyhole slot

centerline

7 n TO wire through top, mark a line

7-l /2” from the right of the centerline on the underside of the cabinet. Mark the point on this line that is l-3/8” from the back wall. Drill a l-l /4” diameter hole through cabinet at this point.

centerline

Non-vented installation

W Put on safety glasses and gloves.

2 1 Check vent baffle on top of range hood. “Non-vented” should be facing up.

3 n Remove knockout from the wiring opening (rear or top) to be used.

Do Not remove venting knockouts.

5 n Lift range hood into final position and center. Mark on underside of cabinet the location for the four keyhole mounting slots. Set range hood aside on a protected surface.

6 H Determine and clearly mark a vertical centerline in the cabinet opening.

To wire through rear, mark a line 7-l /2” from the right of the centerline on the wall. Mark the point on this line that is 64-5J8” from the floor (or l-3/8” from underside of cabinet).

Drill a l-l /4” diameter hole through wall at this point.

8 n Complete Steps 14-l 7. Do Not complete Step 18. The charcoal filter pad is needed in non-vented installation.

/Li!fs!fiiJ!L~

Keep Installation lnstruchons

( Congratulations! )

reference. The instructions will make reinstalling your Whirlpool range hood in another home as easy as the first

installation.

Panel D