Electric Dryer
Electrical requirements
If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.
Important: Observe all governing codes and ordinances.
A
Recommended ground method
It is the personal responsibility and obligation of the customer to contact a qualified electrician to assure that the electrical installation is adequate and in conformance with the National Electrical Code, ANSI/NFPA 70 — latest edition*, and all local codes and ordinances.
Copies of the standards listed above may be obtained from:
*National Fire Protection Association One Batterymarch Park
Quincy, Massachusetts 02269
Now Start...
WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
With dryer in laundry area...
exhaust | fuse |
vent | disconnect |
system | box |
1.Take tape off front corners of dryer. Open dryer and remove the literature and parts packages. Wipe the interior of the drum thoroughly with a damp cloth.
2.Take two of the cardboard corners from the carton and place them on the floor in back of the dryer. Firmly grasp the body of the dryer and gently lay it on its back on the cardboard corners.
3.With one of the legs in hand, check the ridges for a diamond marking. That's how far the leg is supposed to go into the hole.
4.Start to screw the leveling legs into the holes by hand. (Use a small amount of liquid detergent to lubricate the screw threads so it is easier to turn the legs.) Use a
Now stand the dryer up.
Slide dryer onto cardboard or hardboard before moving across floor to avoid damaging floor covering.
5.Move dryer close to final position. Remove cardboard or hardboard from under dryer.
Page 7
