Introduction.

B A

C

D

Location

of washer

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will be preceded by the safety alert symbol and the word “DANGER” or “WARNING”. These words mean:

DANGER

You can be killed or seriously injured if you don’t immediately follow instructions.

WARNING

You can be killed or seriously injured if you don’t follow instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

Important: Observe all governing codes and ordinances.

Check location where washer will be installed. Make sure you have everything necessary for correct installation. Proper installation is your responsibility.

Water heater: Set to deliver 60°C (140°F) water to washer.

Earthed electrical outlet (A) is required within 152 cm

(5 feet) of upper left corner of washer cabinet. See “Electrical requirements,” Page 4.

Hot and cold water faucets (B): Must be within 122 cm (4 feet) of the upper right corner of the washer cabinet and provide water pressure 34.5-689.6 kPa (5-100 psi).

The hot and cold water inlets on the back of the washer have 3/4 — 11-1/2 American hose coupling standard threads.

Level floor (C): Maximum slope under entire washer — 2.5 cm (1 inch).

Support (D): Floor must be sturdy enough to support washer weight (with water) of 143 kilograms (315 pounds).

The minimum and maximum motor rotation per minute (R.P.M.) is 1140-1725 R.P.M. The minimum and maximum basket R.P.M. is 423-640 R.P.M.

Do Not store or operate washer below 0°C (32°F) (some water may remain in washer).

See Use & Care Guide for “Winterizing” information.

60

(A) 152

4

(B) 122

34.5-689.6

3/4 11-1/2

(C)

2.5

(D)143

1140-1725 /423-640 /

0

A

D

 

Tools needed

 

 

for installation

 

E

 

 

A. level

D. pliers

C

 

 

B. wrench

E. scissors

B

 

C. utility knife

A.

D.

B.

E.

C.

 

 

D

Parts supplied

 

C

for installation

A

 

Remove parts from packages. Check that all parts were included.

F

E

 

G

 

 

A. 1 drain hose

F. 4 flat water hose

 

 

 

 

B. 2 inlet hoses

washers

 

 

C. 1 yellow clamp

G. 1 hose extension

 

 

D. 2 drain hose clamps

H. literature package

 

B

E. 2 front leveling legs

 

 

with nuts

 

 

H

 

 

A. 1

E. 2

B. 2

F. 4

C. 1

G. 1

D. 2

H.

2

Page 2
Image 2
Whirlpool 8318507 Introduction, Location Washer, Earthed electrical outlet a is required within 152 cm