Electrical

requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3-prong outlet.

Do not remove ground prong. Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.

Important: Observe all governing codes and ordinances.

A four-wire or three-wire, single phase, 120/240-volt, 60-Hz, AC-only, electrical supply (or four-wire or three-wire, 120/208-volt if specified on model/serial rating plate) is required on a separate 30-ampere circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recommended.

Recommended ground method

It is the personal responsibility and obligation of the customer to contact a qualified electrician to assure that the electrical installation is adequate and is in conformance with the National Electrical Code, ANSI/NFPA 70 — latest edition* and all local codes and ordinances.

Copies of the standards listed may be obtained from:

*National Fire Protection Association One Batterymarch Park

Quincy, Massachusetts 02269

Exhaust requirements

WARNING

Fire Hazard Use a heavy metal vent. Do not use a plastic vent. Do not use a metal foil vent.

Failure to follow these instructions can result in death or fire.

•Do Not use non-metal flexible vent, or exhaust hoods with magnetic latches.

•Do Not exhaust dryer into any gas vent, chimney, furnace, cold air vent, wall, ceiling, concealed space of a building, attic or crawl space, or any other vent used for venting.

•Do Not install flexible vent in enclosed walls, ceilings or floors.

Important: Observe all governing codes and ordinances.

Exhaust your dryer to the outside. Moisture and lint indoors may cause:

•Lint to gather around the dryer where it can be fuel for a fire.

•Moisture damage to woodwork, furniture, paint, wallpaper, carpet, etc.

•Housecleaning problems and health problems.

Dura Safe™ venting products are recommended and are available from your dealer.

Four-inch diameter vent must be used.

Use a heavy metal vent. Do Not use plastic or metal foil vent.

Rigid metal vent is recommended to prevent crushing and kinking.

Flexible metal vent must be fully extended and supported when the dryer is in its final position. Remove excess flexible vent to avoid sagging and kinking that may result in reduced air flow.

An exhaust hood should cap the exhaust vent to prevent rodents and insects from entering the home.

Exhaust outlet hood

 

 

 

 

 

must be at least 12

 

 

12"

inches from the ground

 

 

minimum

or any object that may

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

be in the path of the

 

 

 

 

 

 

 

 

 

 

exhaust (such as

 

 

 

 

 

flowers, rocks or

 

 

 

 

 

bushes, etc.).

 

 

 

 

 

If using an existing exhaust system, clean lint from entire length of system and make sure exhaust hood is not plugged with lint. Replace any plastic or metal foil vent with rigid metal or flexible metal vent.

Use clamps to seal all joints. Do Not use duct tape, screws or other fastening devices that extend into the interior of the vent to secure vent.

Service check: Back pressure in any exhaust system used must not exceed

0.6inches in water column measured with an incline manometer at the point that exhaust vent connects to dryer.

5

Page 4 Page 6
Page 5
Image 5
Whirlpool 8535840 installation instructions Recommended ground method, Quincy, Massachusetts
Page 4 Page 6

8535840 specifications

The Whirlpool 8535840 is a versatile and highly efficient appliance designed to elevate the cooking experience in the modern kitchen. This product is primarily known for its functionality as a microwave oven, catering to the need for fast and convenient meal preparation. One of its standout features is its user-friendly interface, making it accessible for individuals of all cooking skill levels.

One of the main features of the Whirlpool 8535840 is the Sensor Cooking technology. This innovation allows the microwave to automatically adjust cooking time and power levels based on the moisture released from the food being cooked. As a result, it helps in achieving optimal cooking results without the need for constant monitoring, which is ideal for busy lifestyles. Whether reheating leftovers or cooking a meal from scratch, this feature ensures that food comes out perfectly cooked every time.

In addition to Sensor Cooking, this model also boasts a microwave popcorn setting, which takes the guesswork out of making popcorn. With just the press of a button, it can detect the proper cooking time needed for various types of popcorn, ensuring a perfect, fluffy snack. This level of convenience is a major selling point for many consumers.

The Whirlpool 8535840 is also designed with a spacious interior, allowing it to accommodate larger dishes and containers, which is a significant advantage over many compact models. This feature is particularly beneficial for families or individuals who like to meal prep.

Another characteristic worth noting is the sleek exterior design, which enhances the aesthetic appeal of any kitchen. Available in a variety of finishes, it can seamlessly blend with existing kitchen decor while providing the durability necessary for day-to-day use.

Furthermore, the appliance incorporates multiple power levels, offering versatility in cooking options. Users can choose from various settings depending on the type of food being prepared, whether they are defrosting meat or melting butter.

Energy efficiency is another key aspect of the Whirlpool 8535840. With an emphasis on reducing electricity consumption, this model is designed to be eco-friendly without compromising on performance.

Overall, the Whirlpool 8535840 is a top-tier microwave that combines innovative cooking technologies with practical features, making it a valuable addition to any kitchen.
Top Page Image Contents