Operating Instructions Continued
Option selector buttons
Cycle control knob
Startingyour dishwasher
1.Push a Cycle Selector Button for the desired cycle. Normal Wash, Light Wash and Rinse 8 Hold Cycles share the same button. The Cycle Control Knob determines which cycle operates,
2.Push an Option Selector Button for each desired option. (Use AIR DRY for Rinse & Hold Cycle.) The indicators above the buttons will show which cycle and option(s) have been selected.
3.Turn Cycle Control Knob clockwise to point to a desired cycle. Heavy Wash and Pots & Pans Cycles share the same spot on the dial. The Cycle Selector Buttons determine which cycle operates.
You will feel a definite stop at each cycle mark. The dishwasher will automatically start that cycle.
NOTE: If the door is latched, you will hear cycles start and stop as the knob passes each cycle mark. This is normal and will not hurt the dish- washer, If you prefer, you can set cycles with the door unlatched.
Toadd a dish after starting
1.To be sure the added item is washed and rinsed, make sure the Cycle Control Knob has not passed LIGHT WASH.
2.Lift up on the door latch to unlatch door and stop the cycle. Don’t open the door until the
‘spray arms stop spinning.
3.Open the door and add the dish.
4.Close the door. Do not latch it. Wait 30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.
5.Press door in to latch it. The dishwasher will start where it stopped.
