PROBLEM

Washer fills and drains without running

Washer drains during wash and rinse cycles, or water siphons out

POSSIBLE CAUSE

Cycle control knob is not pointing to a number in the cycle.

Drain hose is lower than the water level in the washer.

SOLUTION

Set cycle control knob on correct number in the cycle.

Adjust drain hose so that it is higher than the water level in the washer.

2.If your problem is not due

to one of the items listed in Step 1 . . .

Contact the dealer from whom you purchased the unit or an authorized Whirlpool service company.

3.If you need FSP* replace- ment parts . . .

FSP is a protected trademark of Whirlpool Corporation for quality parts. Look for this symbol of quality whenever you need a replacement par-tfor your Whirlpool appliance. FSP replacement parts will fit right and work right, because they are made to the same exacting specifications used to build every new Whirlpool appliance. To locate FSP replace- ment parts in your area, contact the dealer from whom you purchased the unit or an authorized Whirlpool service company.

assembly covered

23

Page 23
Image 23
Whirlpool 8LSC6244BG0 manual If you need FSP* replace- ment parts, Set cycle control knob on correct number in the cycle