Changing a cycle setting You can change a cycle setting anytime
during any cycle.
1. Lift up the door latch to stop the cycle.
2. Turn the Cycle Control Knob clockwise to
the desired cycle.
3. If desired, press one or more Option
pad(s).
4. Check the detergent dispensers. They
must be filled properly for the new cycle.
NOTE: Turning the Cycle Control Knob
can cause the covered section of the
detergent dispenser to open and release
the detergent. Check the covered section
if setting NORMAL or POTS-N-PANS
cycle.
5. Close the door firmly until it latches. The
dishwasher starts the new cycle.
Changing an option setting You can change option settings anytime 1. Press the RESET OPTIONS pad.
. . 0
ii
during a cycle as long as the
cycle has not passed the point 2. Press one or more Option pad(s).
that the option is used. For
example, you can press AIR DRY
anytime before the Cycle Control
Knob reaches DRY.
Adding an item during a cycle You can add an additional item to the 3. Close the door, but do not latch it. Wait
dishwasher anytime before the Cycle 30 seconds for the air in the dishwasher
Control Knob reaches LIGHT. Items added to warm up. Doing so reduces the
after the Cycle Control Knob reaches LIGHT amount of moisture in the vent when
will only be rinsed. restarting a cycle.
1. Lift up the door latch to stop the cycle. 4. Close the door firmly until it latches. The
Wait for spraying action to stop before dishwasher resumes the cycle.
opening the door.
2. Open the door and add the item.
14