JVC TK-C553 manual Menu Screen Settings
Communication menu screen,
Function menu screen

SYSTEM

System with Remote Control Unit RM-P2580

Settings

CAMERA FACE

MONITOR

			NOT USED	INT	LL
			NOT USED	OFF	ON
		INT	L/L
		OFF	ON
		TERMINATION
LOCK	LEFT AWC	UP RIGHT SET

DOWNTERMINATION

•Video synchronization selector switch (INT/LL)

Set to LL (Line Lock) on all cameras, and align V.PHASE.

( See page 29.)

•Control signal termination ON/OFF switch

(TERMINATION OFF/ON)

Set this to ON only on the camera placed at the end of the control signal cable. Set to OFF on all other cameras.

Menu Screen Settings

COMMUNICATION menu screen

•MODE item: Set to DUPLEX

•STYLE item: Set to MULTIDROP

•ID item: Set the camera ID.

For each camera, match the ID with the VIDEO INPUT number of the RM-

P2580.

*Settings on the COMMUNICATION menu screen are performed using the operation buttons on the front section of the camera.

MEMO

Following selection of MEMORY, the settings on the COMMUNICATION menu will not be valid before the power has been turned on again.

FUNCTION menu screen

Screen for making settings related to the Auto Patrol and Auto Pan functions and display of text.

•Settings on the FUNCTION menu are performed using the operation buttons on the RM-P2580. They cannot be made using the operation buttons on the camera body.

•Make settings on other menus as required.

MEMO

When operating a system using the RM- P2580, several cameras (up to 16) can be connected and used on one control signal cable. Consequently, an incorrect switch setting on just a single camera will cause the entire system to work incorrectly.

•Confirm switch settings on the screen as follows.

q Confirm that the image from the camera to be checked is displayed on the monitor. w Turn OFF and then ON the power to the

camera to be checked.

e When the STYLE item is MULTIDROP, characters similar to those shown in the figure below are displayed for about 5 seconds. They do not appear in the case of POINT to POINT.

r Confirm that “DUPLEX” and “ID-MM” are displayed and that the ID number is the correct number (the number should be the same as the number of the VIDEO INPUT terminal to which the camera is connected on the rear panel of the RM-P2580).

t If wrong, set the MODE item, STYLE item and camera ID again.

MONITOR screen

Monitor screen (example showing camera ID as “05”)

P R O T O C O L : D U P L E X I D - 0 5

“DUPLEX” should be	The number shown in
displayed.	the MM part of ID-
	MMshould be correct.

14