7
If a high-intensity object (such as a lamp)
is shot, the image on the screen may have
vertical lines (smear) or blur (blooming) at
its periphery. This is a characteristic of the
CCD, and is not a defect.
Resolution decreases as the digital zoom
ratio is increased.
Do not touch the dome cover of the lens
directly with your hand, contamination of
this cover will lead to a deterioration of the
picture quality.
Observe the following when carrying out
camera maintenance.
Turn the power OFF before proceeding
to carry out maintenance.
Clean the dome cover lens using a lens
wiper cloth (or a tissue).
If it is contaminated seriously, clean the
contaminated part with a cloth (or a tissue)
which has been soaked in a solution of
water and a neutral detergent.

Precautions for Use with the RM-P2580

The focus button will be inoperative.
The Pan/Tilt speed becomes as shown in
the following table.
During auto pan operation, the PAN/TILT
and ZOOM buttons remain inoperative.
The auto pan start/stop positions cannot be
set.
Auto patrol works.
See page 41.
Safety Precautions
Installation of this unit requires expertise.
Please contact your dealer for details.
The ceiling to mount the TK-C553 has to
be strong enough to support ten times the
weight of this product.
If the ceiling is not strong enough, make
sure to apply reinforcement to the ceiling
before installation.
Be sure to tighten the screws and nuts se-
curely, Insufficient tightening may cause the
unit to fall from its mount.
The unit is to be powered by a DC 12 V or
an AC 24 V power supply.
The AC 24 V power supply should conform
to the following:
Isolated power supply only (E type)
Class 2 only (U type)
RM-P2580 P/T SPEED 2 4 6 8
TK-C553 operation 2 4 4 4