Whirlpool 9762354A manual Electronic Oven Controls

ELECTRONIC OVEN CONTROLS

Style 1 - Electronic Oven Controls (on some models)

A B C D E

F G H I J K L M

A. Display	H. Warming drawer
B. Timer	(on some models)
C. Clock	I. Temperature
D. Auto clean	J. Timed cooking
E. Oven light pad	(on some models)
	K. Hour/minute
(on some models)
F. Sequence programming	(on some models)
	L. Start/control lock
(on some models)
G. Oven settings	M. Cancel

Style2 - Electronic Oven Controls (on some models)

AB C D E F

K	J	I	H	G
A. Oven display				G. Temperature/time
B. Clock				H. Cook time
C. Timer/cancel				I. Start time
D. Start/enter (control lock)				J. Custom broil
E. Auto clean				K. Bake
F. Off/cancel

Display

When power is first supplied to the appliance, “PF” or a flashing time will appear on the display. Press CANCEL or OFF/CANCEL to clear “PF” or flashing time from the display.

If “PF” or flashing time appears, a power failure has occurred. Press CANCEL or OFF/CANCEL and reset the clock if needed.

When the oven is not in use, the display shows the time of day.

When performing a timed cook function, the display will show either hours and minutes, or minutes and seconds.

Start

The START or START/ENTER pad begins any oven function. If not pressed within 5 seconds after pressing a function pad, the “START?” indicator light will flash as a reminder. On some models, “START?” will appear on the display.

If not pressed within 5 minutes after pressing a function pad, the oven display will return to the time of day mode and the programmed function will be canceled.

Cancel or Off/Cancel

The CANCEL or OFF/CANCEL pad stops any function except the Clock, Timer and Control Lock.

Clock

On some models, this is a 12-hour clock that shows a.m. and p.m.

To Set:

Before setting, make sure the oven and Timer are off.

1.Press CLOCK.

2.Depending on your model, press the HR or MIN or TEMP/ TIME “up” or “down” arrow pads to set the time of day, including a.m. or p.m.

3.Press CLOCK or START.

Tones

Tones are audible signals, indicating the following:

One tone

■Valid pad press

■Oven is preheated (long tone)

■Function has been entered

■Reminder, repeating each minute after the end-of-cycle tones

Three tones

■Invalid pad press

Four tones

■End of cycle

Reminder Tones: Reminder tones may be turned off. On some models, press and hold STOP TIME for 5 seconds. “rEP OFF” or “off” will appear in the display. Repeat to turn reminder tones back on, and “rEP on” or “on” will appear in the display.

All Tones: All of the above tones are preset on. All except the end-of-cycle tones can be turned off.

8