INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Tools needed
■Phillips screwdriver
■Hand or electric drill
■1³⁄₈" (3.5 cm) hole saw
Parts supplied
■Two
■Lens (for panel ready models)
Check local codes. Check existing electrical supply. See “Electrical Requirements.”
It is recommended that all electrical connections be made by a licensed, qualified electrical installer.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
■ Cutout dimensions that are shown must be used. Given |
dimensions provide minimum clearance with warming drawer. |
■ Recessed installation area must provide complete enclosure |
around the recessed portion of the warming drawer. |
■ Grounded electrical supply is required. See “Electrical |
Requirements” section. |
■ Electrical supply outlet should be located in the rear wall on |
the upper |
cabinet. The outlet must be recessed. If the electrical outlet is |
located in an adjacent cabinet, a 1³⁄₈" (3.5 cm) minimum |
diameter hole should have been drilled in the back of the |
cutout or support surface to pass the power supply cord |
through to the outlet. |
■ Warming drawer support surface must be solid, level and flush |
Product Dimensions
B
C
A
WARMING | OVERALL | RECESSED | RECESSED |
DRAWER | WIDTH (A) | WIDTH (B) | HEIGHT (C) |
SIZE |
|
|
|
|
|
|
|
24" | 23³⁄₄" | 22¹⁄₄" | 9" |
(61 cm) | (60.3 cm) | (56.5 cm) | (22.9 cm) |
|
|
|
|
27" | 26³⁄₄" | 25¹⁄₄" | 9" |
(68.6 cm) | (67.9 cm) | (64.1 cm) | (22.9 cm) |
|
|
|
|
30" | 29³⁄₄" | 28¹⁄₄" | 9" |
(76.2 cm) | (75.6 cm) | (71.8 cm) | (22.9 cm) |
Cabinet Dimensions
Cabinet Side View
with bottom of cabinet cutout. |
For best performance results make sure the warming drawer is leveled before completing installation. There is no way to level the warming drawer after it has been installed. If the installation is not level, the door may slide open or not seal tightly, allowing heat to escape.
Warming drawer front
Support surface must be solid, level, flush with bottom of cabinet cutout.
22³⁄₄"
(57.8 cm) recessed oven depth
24"
(61 cm)
min. cutout
depth
2