INSTALLATION INSTRUCTIONS
Install Warming Drawer
WARNING
Excessive Weight Hazard
Use two or more people to move and install warming drawer.
Failure to do so can result in back or other injury.
1.Turn off power supply. Using 2 or more people, move warming drawer close to its final location. Remove and discard shipping materials, tape, and protective film from the warming drawer. Remove and set aside racks and other parts from inside warming drawer.
2.Make sure the that the warming drawer Temperature control knob is set to the OFF position.
3.Support the warming drawer on a sturdy surface level with the cutout opening.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
4.Plug the power supply cord into the grounded 3 prong outlet.
5.Slide the warming drawer over half way into the cutout opening.
6.Open warming drawer and slowly push against the front panel to slide the drawer completely into the cabinet until the flanges on the front panel meet the cabinet face.
7.Use the two
A
A. Two
Complete Installation
1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
2.Check that you have all of your tools.
3.Dispose of/recycle all packaging materials.
4.For warming drawer use and cleaning, read the Use and Care Guide.
5.Turn the Temperature control knob to HI, and the red light should illuminate.
If warming drawer(s) does not operate, check the following:
■Household fuse is intact and tight; or circuit breaker has not tripped.
■Warming drawer is plugged in and, electrical supply is connected.
If you need Assistance or Service:
Please reference the “Assistance or Service” section of the Use and Care Guide or contact the dealer from whom you purchased your warming drawer.
4
