Whirlpool 98015194 Parts supplied for installation, Cutout dimensions/requirements

Parts supplied for installation:

anti-tip bracket

Not shown:

• literature pack

• orifice spuds

2 screws (#10 x 1-1/2")

2 plastic anchors

(Bracket must be securely mounted to sub-floor. Thickness of flooring may require longer screws to anchor the bracket to sub-floor.)

Product dimensions

26-3/4"
(67.9 cm)
depth with
handle
Proper gas supply	36"
	(91.4 cm)
connection must be
	cooktop
available. See “Gas	height
supply requirements,“	46-1/4" (117.5 cm)
Page 4.
Grounded electrical	overall height for
	tall backguard
outlet is required.	models
See “Electrical
requirements,“
Page 4.
24-1/4"
(61.6 cm)
	29-7/8" (75.9 cm)
	width

Cutout dimensions/requirements

Check location where range will be installed. The range should be located for convenient use in the kitchen. Recessed installations must provide complete enclosure of the sides and rear of range.

All openings in the wall or floor where range is to be installed must be sealed.

18" (45.7 cm) min. clearance upper side cabinet to countertop

13" (33 cm) max. upper cabinet depth

30" (76.2 cm) min. cabinet opening width

30-1/8" (76.5 cm) opening width

2" (5.1 cm) min. countertop space to side wall or other combustible material

This shaded area recommended for installation of gas

For minimum clearance to top of cooktop, see NOTE.*

IMPORTANT: Some cabinet and building materials are not designed to withstand the heat produced by the oven for baking and self-cleaning. Check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage.

*NOTE: 24" (61 cm) min. when bottom of wood or metal cabinet is protected by not less than 1/4" (0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015"

(0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.

30" (76.2 cm) min. clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.

This shaded area recommended for electrical outlet.

pipe.

10"

24" (25.4 cm) (61.0 cm)

Do not seal the range to the side cabinets.

If cabinet depth is greater than 24" (61 cm), oven frame must extend beyond cabinet fronts by 1/2" (1.3 cm) min.

Contact a qualified				8"
floor covering
			5"	(20.3 cm)
installer to check that		2"
the floor covering			(12.7 cm)
		(5.1 cm)
can withstand at
		5"
least 200°F.	3"
Use an insulated pad		(12.7 cm)

or 1/4" plywood	(7.6 cm)
under range if
installing range over
carpeting.

Anti-tip bracket:

The floor anti-tip bracket must be installed. To install the anti-tip bracket shipped with the range, see Page 5 and the anti-tip bracket template.

3