Caring For Your Air Conditioner
Continued
Electrical Shock, Product Damage and
Personal Injury Hazard
l Unplug power cord from receptacle before performing any maintenance. De sure no liquid gets into the motor, electrical control box or compressor electrical terminals.
l Do not lift, push or pull any white beaded foam (expanded polystyrene) parts.
l
l
l
Because your air conditioner weighs from 110 to 200 pounds, it is recommended that you have someone help you when you remove and
Handle the air conditioner with care. Watch out for the sharp metal fins on the front and rear condenser coils.
Do not use the collected water for drinking purposes. lt is not sanftary.
Failure to follow the above precautions could result in electrical shock, product damage or personal injury.
1. Unplug power cord.
2Remove front panel. (See page 5 for instructions.)
3.Slide unit out of cabinet by using the handle in the center of the base flange.
4.Wrap the motor, connector plug, electrical control box and compressor terminal box in plastic film and make sure no water or other liquid gets inside any of these parts. It could damage the insulation and cause serious mechanical problems.
5.Carefully clean and hose out the base, con- denser coils and condensate pans. Clean at least once a
6.Remove plastic film from motor and electrical parts.
7.Replace unit in cabinet.
6.Replace front panel.
9.Plug in power cord.
NOTE: ft is a good idea to wait 24 hours before starting the unit again. This allows for all areas to dry out. The water from rainfall or from normal operation does not harm these components.
