GB -5-
Rectifying minor faults yourself ...
Switch off the appliance Everything o.k. ...
Wash cycle
Select programme Quick, permanent or alternating
109678Exercise caution when opening the door: beware of hot steam.
Only press the OFF button once the START indicator lamp has switched off.
All the indicator lamps switch off. Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.
Maintenance and care
Filters
check and
clean if
necessary
Rotate filter
cylinder, remove
filter system ...
Rinse under
running water ... Screw on filter
system
NOTE MARK!
Unscrew
upper arm ...
Spray arms
Remove
blockages/
deposits.
Insert
Pull
lower arm
upwards ...
Clean spray
nozzles under
running water
(use toothpicks
if necessary) ...
Screw on upper arm tightly
Insert lower arm ...
Maintenance and care
Change the programme in progress:
• Press the START button (for 2 seconds) until the START indicator lamp
switches off.
• Close the door.
• (Water drains for up to 60 seconds).
• Open the door.
• Select a new programme.
• Press the START button.
Overview of programmes
The max. possible number of programmes is illustrated in the chapter “Chart”. The corresponding programmes for your appliance can be found on the panel (page 1).
Choose programme according to the attached table of programmes (page 1).
Duration of the programme depends on the external conditions in the apartment, temperature and pressure etc.
The dishwasher door must be closed and the water tap open.
To load crockery, open the door with caution:
Close the door again.
The programme resumes the cycle from where it was interrupted.
Beware of hot steam!
The wash cycle can be interrupted at any time by RESET (see chapter “What to do if”).