How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Open the door,
switch on the appliance
How to fill the
detergent dispenser
Check the rinse aid level
Check the regeneration
salt level
Load the racks
Select a programme
Select options
Press the ON button. |
|
|
|
Large compartment A: |
|
| C |
With each wash cycle. | A | B | |
Small compartment B: |
|
|
|
For programmes with |
|
|
|
Mechanical indicator lamp C.
Electric indicator on control panel (if provided).
On models with water softener system only. Mechanical indicator lamp D. Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Press the 
button until the desired programme lights up.
If necessary (and if provided)
the corresponding indicator lamp lights up.
Press the Start button
Turn on the water tap
close the dishwasher door
Wash cycle
The selected programme is then memorised (even in the event of power failure).
“Change programme”
Press the START button for 2 sec. until the Start indicator lamp switches off;
Select another programme and press the START button again.
-Only open the dishwasher if necessary (Warning: beware of hot steam).
-If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.
Switch off the appliance
Turn off the water tap,
unload the racks
At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the OFF button. All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
WH/II/FD/GB
