Whirlpool ADG 7952 What to do if, Problem, Cause, Remedy, The appliance is not, working, faded

What to do if...

If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions).

	Problem		Cause		Remedy
The appliance is not		•	No water supply.	•	Open the tap.
working
		•	The appliance does not load	•	Clean the water supply tap filter.
			sufficient water.	•	Ensure there are no kinks in the water hose.
		•	There is a power failure.	•	Insert the plug into the mains socket.
				• Press the Start button.
				•	Close the door.
				• Check the domestic circuit fuse.
		•	Starting the selected programme.	•	The programme can be set to “0” to start.
If crockery is not		•	Insufficient rinse aid.	•	Increase dosage *.
perfectly dry
		•	Residual water in cavities.	•	Load crockery at an angle.
If crockery is not		•	The water jet does not reach	•	Arrange crockery so that items do not touch each
perfectly clean			the crockery.		other.
					Load crockery upside down.
		•	Insufficient detergent.	•	Follow recommended detergent dosage.
		•	Unsuitable programme.	•	Select a more intense wash cycle.
		•	Spray arms blocked.	•	The spray arms must be able to turn freely.
		•	Spray arm nozzles clogged.	•	Remove any impurities obstructing the water flow *.
		•	Incorrect detergent/detergent too old.	•	Use a good quality detergent.
Sandy or grainy residues		•	Clogged filters.	•	Check filters regularly/if necessary clean *.
		•	Filters incorrectly assembled.	•	Insert the filter correctly *.
Colour of plastic parts		•	Tomato/carrot juice,...	•	Depending on the material, if necessary use a
faded					detergent with a greater whitening power.
Deposits on crockery
•	removable	•	Streaks on the crockery/glasses.	•	Increase the rinse aid dosage *.
		•	Streaks on glasses.	•	Reduce the rinse aid dosage *.
		•	Layer of salt on crockery/glasses.	•	Close the salt container lid properly *.
•	not removable	•	Insufficient water softening,	•	Change water hardness setting, if necessary add
			calcium deposits.		salt *.
Opaque glasses/ glasses		•	Cannot be washed in the dishwasher.	•	Use suitable glasses.
not sparkling
Rust on cutlery		•	Not made of stainless steel.	•	Use suitable cutlery.
Identifying appliance		•	The START indicator lamp flashes.	•	Ensure that the filter assembly is not clogged and
faults					if necessary clean it *.
					Start the programme again. Press the Start button for
					2 seconds, until the Start indicator lamp switches
					off. Select a new programme and press the Start
					button again.
		•	Indicator F... (if provided).	•	Call the After-Sales Service.

If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee).

Before contacting our After-Sales Service, take note of the following:

•The nature of the fault.

•The appliance type and model.

•The service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side.

WH/IV/GB